DockView RFID portal simulator
Set up a DockView dock portal: reader, antennas, power, tag and pallet load. See an estimate of how many tags each pass reads.
Loading the simulator…
© Identix. All rights reserved. This simulator, its code and its data are proprietary. Copying, reuse or redistribution without written permission from Identix is not allowed.
What this simulator calculates
It estimates how many RAIN RFID tags a DockView dock portal reads when a load goes through the door, pass after pass. Each pass varies the fading and the tag lot, so the result is a spread of passes, not a single number.
What you can set
- Reader: EZ700, EZ500 or EM300, with Impinj Gen2X on or off.
- One to four antennas (65C6095, 75L9090, 85C7070, 85DL4090 or 90C4090), their height, polarization, power, cable loss and RSSI filter.
- Door width and the tilt of the towers, up to 30° either way.
- The load: boxes on a pallet with box tags or item-level tags and the product inside, a stack of plastic or wood sheets, or car tyres.
- The vehicle (forklift or roll container), the speed and the environment.
What you see
- The tags a typical pass reads, and the read failures as a count of tags over the simulated passes.
- The same setup with Impinj Gen2X on and off, side by side.
- A 3D view of the pass: the lobe of each antenna, the zone where a tag is read in at least 90% of the tries, and the chance of a read per tag.
- Notes on the setup, such as the EIRP of each antenna against the local limit you type in.
- Stray reads: how often goods that must not be read (beside the reader, the next load, a neighbour) are read, with an alert and how to reduce them.
Questions about the simulator
Is the simulator free? Do I need to install anything?
It is free and runs in the browser, with no sign-up and nothing to install. It needs JavaScript and a browser with WebGL for the 3D view.
Does the result replace a test on site?
No. It is an estimate from a propagation model, the antenna patterns and premises from the literature. Use it to compare setups and prepare the project, then confirm with a pilot on site, with the real tags and products. Identix can help you plan that test.
Who is it for?
For system integrators, meaning any company that builds its own solution, in full or in part: software companies that use Identix readers, makers of their own portals or reading cabinets who buy only antennas or readers, and also installers and end users who are planning a project.
Can I simulate a roll container or a stack of sheets?
Yes. Choose the roll container as the vehicle, with parcels or sacks inside, or choose a stack of plastic or wood sheets or car tyres as the load. Sheet losses come from the literature, and the simulator takes the conservative end of each range.
What is a stray read and how do I reduce it?
A read of a tag that did not pass through the door: a pallet waiting at the next dock or going through it at the same time, pallets in staging, stock on shelving or goods already in the truck. Turn on these scenes in the simulator to see how often the portal reads them and which power, RSSI filter or distance fixes it. Lowering the power alone rarely helps, because the load stops being read first; distance, a metal wall or curtain between docks, the RSSI filter, a photocell that opens the reading window and the direction from the order of the antennas are what reduce them.