Home / Tools / Simulators / LineView simulator

LineView RFID tunnel simulator

Run one box through the LineView conveyor tunnel, with tags on the items inside it. See an estimate of how many item tags each pass reads.

Loading the simulator…

Product page: LineView

What this simulator calculates

It estimates how many item-level RAIN RFID tags the LineView conveyor tunnel reads in one box that runs through it on the belt. Each pass varies the fading and the tag lot, so the result is a spread of passes.

What you can set

  • Reader: EZ700, EZ500 or EM300, with Impinj Gen2X on or off.
  • The four antennas (85C7070, 75L9090, ANTNF0 or ANTNF1), each switched on or off, with its polarization, power and cable loss.
  • Conveyor speed, box size and how far the box runs off the centre of the belt.
  • The product inside, how many items and the tag model.

What you see

  • The tags a typical pass reads, and the read failures as a count of tags over the simulated passes.
  • The same setup with Impinj Gen2X on and off, side by side.
  • A 3D view of the pass: the lobe of each antenna, the zone where a tag is read in at least 90% of the tries, and the chance of a read per tag.
  • Notes on the setup, such as the EIRP of each antenna against the local limit you type in.
  • Stray reads: how often goods that must not be read (beside the reader, the next load, a neighbour) are read, with an alert and how to reduce them.

Questions about the simulator

Is the simulator free? Do I need to install anything?

It is free and runs in the browser, with no sign-up and nothing to install. It needs JavaScript and a browser with WebGL for the 3D view.

Does the result replace a test on site?

No. It is an estimate from a propagation model, the antenna patterns and premises from the literature. Use it to compare setups and prepare the project, then confirm with a pilot on site, with the real tags and products. Identix can help you plan that test.

Who is it for?

For system integrators, meaning any company that builds its own solution, in full or in part: software companies that use Identix readers, makers of their own portals or reading cabinets who buy only antennas or readers, and also installers and end users who are planning a project.

Where are the tunnel antennas?

Two under the belt looking up and one on each side wall looking in. You can switch any of them off to see what each one adds; at least one stays on.

What is a stray read and how do I reduce it?

A read of a tag that is not in the box going through the tunnel, such as the box right behind it on the belt. Turn on the next box in the simulator to see how often it is read. A larger gap between the boxes, RF curtains at the openings, a lower power and reading only while a photocell sees the box inside the tunnel reduce it.